USER'S GUIDE ____________________________________________________________________
32 ___________________________________________________________________ M211187EN-C
Assembling FS11
To assemble the FS11 system, proceed as follows:
1. Mount the base plate and level it with six M16 nuts (see Figure 8
below).
NOTE
If the frangible mast length is more than
3 meters, do not install the
supplied in the Foundation kit FS211296.
2. If you are installing a frangible mast, mount the pole mast pedestal
on the base plate with three M16 nuts (see Figure 10 on page 34)
and an M8 hinge bolt. For the M16 nuts use the wrench supplied
with the FSA11 kit.
0201-060
Figure 8 Mounting FS11 Mast Using Foundation Kit
FS211296
The following number and letter refer to Figure 8 above:
Background luminance sensor viewing direction (normally
North in the Northern hemisphere and South in the Southern
hemisphere)
To Next Page
Loading...
