Vaisala FS11 - Figure 13 Tilting Aluminum and Frangible Pole Masts

USER'S GUIDE ____________________________________________________________________
36 ___________________________________________________________________ M211187EN-C
7. Attach the FSI102 interface unit to the rear panel of the radiation
shield (see Figure 19 on page 40). The upper end of the interface
unit is mounted by inserting the hook at the back of the interface
unit into the groove in the rear panel. The lower end is mounted
with two screws.
NOTE
If the tilting support has been removed due to the length o
f the mast, a
temporary tilting support is needed.
0201-067
Figure 13 Tilting Aluminum and Frangible Pole Masts
NOTE
The measurement unit cable has to be fed into the mast before the signal
and power cables, or the cable
connector does not fit through the hole in
the mast.
8. Check that there is a thin rubber o-ring gasket around the insertion
neck of the measurement unit FSM102. See Figure 14 on page 37.