USER'S GUIDE ____________________________________________________________________
140 __________________________________________________________________ M211187EN-C
Replacing FSC102
1. Open the central compartment cover of the VS, see Figure 44 on
page 141.
2. Make sure that the visibility sensor is switched off
3. Disconnect the (5 pcs.) terminal plugs.
4. Disconnect the transmitter and receiver control cables. Use the
special tool to unlock the connectors.
5. Remove the four visibility sensor CPU mounting screws.
Figure 43 Visibility Sensor Controller FSC102
6. Remove the FSC102 carefully from the central compartment and
insert spare item. Pay attention to the cable routing in order not to
stress or damage any wires.
7. Insert and tighten the four mounting screws.
8. Re-connect (5 pcs.) terminal plugs. Pay attention to the correct
order.
- Start with terminal #1 (see Figure 43 above).
- Numbers have to increase counter-clockwise.
9. Connect transmitter and receiver control cable plugs. Pay attention
that the connector locking mechanism has arrested.
Transmitter
Control Cable
To Next Page
Loading...
