Vaisala FS11 - MESSAGE 3, Status Message

USER'S GUIDE ____________________________________________________________________
76 ___________________________________________________________________ M211187EN-C
MESSAGE 3, Status Message
The status message contains the results of the built-in tests. These
numerical internal monitoring measurement values can be requested with
the STATUS command. The short status check message, which contains
a short, clear language report of the system status can be requested with
command STATUS CHECK. Refer to section FS11 Status Messages on
page 111.
Example of status message:
!
FSA
∀
FS11 SYSTEM STATUS: OK
Measurement unit: OK
Receiver:
Window cont: 0 backscatter: 35
DC saturation: 0 offset: -0.09
Transmitter:
Window cont: 0 backscatter: 8
Intensity: 162
Contamination compensation: ON
Temperatures (unit C):
surface: 22.8 CPU: 27.8 RX: 27.3 TX: 29.3 hood RX: 20.3
Hood TX: 21.0
Voltages:
+12V: 11.4 -12V:-11.3 VB: 12.5 VR: 6.7
Heater status:
Hood TX: OFF, hood RX: OFF, dew: OFF
Interface unit: OK
Temperatures (unit C):
CPU: 27.1, external: /////
Humidity: ////
Voltages:
+12V: 12.1 +12Vout: 0.0 PVin: 23.8 V5I: OFF
Background luminance sensor: OK
Window cont: 10
Contamination compensation: ON
Backscatter: 0
CPU: 26.2 hood: 24.6
Heater status: hood: OFF, dew: OFF
V5iso: ON
#CSUM∃−∗