Chapter 6 _______________________________________________________________ Maintenance
VAISALA _______________________________________________________________________ 145
5. Open the two screws (number 1 in Figure 48 below) holding the
FSC202 board in place and pull the board out carefully. Disconnect
the connectors (2) from the bottom part of the FSC202 board.
1207-016
Figure 48 FSC202 Screws and Connectors
6. Assemble the new FSC202 board (spare part for FS11P) back in
reverse order.
7. Turn on the power and battery switches. Configure the unit with
correct parameter settings using the commands described in section
Entering and Exiting Command Mode on page 63.
To Next Page
Loading...
