USER'S GUIDE ____________________________________________________________________
42 ___________________________________________________________________ M211187EN-C
18. Attach the interface unit back in its original place in the rear panel.
NOTE
Make sure that the cables are not pressed between the interface unit and
the rear panel.
19. Attach and close the radiation shield as shown in Figure 21 below.
1001-129
Figure 21 Mounting Radiation Shield
Inserting Battery for Optional FSB101
In case an optional battery backup FSB101 is used, a battery charger
module QBR101 is located inside the interface unit. A 2 Ah battery is
packed separately and should be inserted into the interface unit as
follows:
1. Open the shield and interface unit door with the provided key.
NOTE
Make sure the AC (mains) power and the battery backup are both OFF
before you proceed with the next steps.
To Next Page
Loading...
