Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 41
17. If the Obstruction Light option is to be mounted, lift the enclosure
and suspend it from the left-side hole in the rear panel. Install and
make the cabling as shown in Figure 20 below. Refer to Figure 33
on page 59 for the wiring inside enclosure.
NOTE
The cable shield of the Obstruction Light cable must be properly
grounded in the cable gland of the interface unit's enclosure. See
Figure
on page 48.
1011-003
Figure 20 Sensor Arm Assembly
To Next Page
Loading...
