Vaisala FS11 - Figure 10 Mounting FS11 Aluminum Mast Using Foundation Kit FS211296

USER'S GUIDE ____________________________________________________________________
34 ___________________________________________________________________ M211187EN-C
4. If an aluminum mast is to be installed, mount the mast pedestal on
the base plate by first removing the three preinstalled M16 set
screws (see Figure 10 below). Attach the supplied 12-mm guard
plug into the plate and use the four mounting screws supplied with
the Foundation Kit FS211296 to mount the pedestal.
0201-062
Figure 10 Mounting FS11 Aluminum Mast Using
Foundation Kit FS211296
The following numbers and letter refer to Figure 10 above:
1
=
M16 set screws 3 pcs
2
=
Guard plug
3
=
Mounting screws 4 pcs
A
=
Background luminance sensor viewing direction (normally
North in the Northern hemisphere and South in the Southern
hemisphere)
5. Mount the rear panel of the radiation shield to the pole mast with
the two clamps supplied (see Figure 12 below). See that the anti-
sliding gaskets are correctly set between the clamps and the mast.
Screw the bolts from the inside and secure the bolts with nuts from
the outside.
6. Mount the sensor arm by aligning the holes at the end of the sensor
arm's forks with the threads on the back of the rear panel. Fix it in
place with four Allen screws. See Figure 11 on page 35.