USER'S GUIDE ____________________________________________________________________
64 ___________________________________________________________________ M211187EN-C
OPEN Command
If no device identifier (ID) is defined, type:
OPEN
If a single-character ID is defined, for example, as A, type:
OPEN A
If a multi-character ID is defined, for example, 'RWY31', only the first
character of the ID has to be given. Type:
OPEN R
If ID is defined but forgotten, type:
OPEN *
If the device type FS is included in the OPEN command, an ID is not
needed. This device type can be used when there is only one FS11 sensor
on the line. This command is similar to the OPEN * command with the
exception that it only opens the FS11 command mode and not the other
possible sensors on the line. Type:
OPEN FS
If there are other sensors on the line with the same ID, the command
mode of the FS11 sensor can be opened by including the device type FS
with the ID. This command is similar to the OPEN ID command with
the exception that it only opens the FS11 command mode and not the
other sensors on the line with the same ID. If a single-character ID is
defined, for example, as A, type:
OPEN FS A
The FS11 sensor answers:
FS11-A LINE OPENED FOR OPERATOR COMMANDS
If a multi-character ID is defined, for example, 'RWY31', type:
OPEN FS RWY31
The FS11 sensor answers:
FS11-RWY31 LINE OPENED FOR OPERATOR COMMANDS
To Next Page
Loading...
