Vaisala FS11 - Page 70

USER'S GUIDE ____________________________________________________________________
68 ___________________________________________________________________ M211187EN-C
Command
Description
CALIBRATE TEMPERATURE EXTERNAL
value
Makes single point calibration with the external
temperature sensor connected to the interface unit, the
value should be between -99 and 99.
CALIBRATE TEMPERATURE INTERNAL
value
Makes single point calibration with the boom (FSM102)
temperature sensor in the measurement unit, the value
should be between -99 and 99.
CALIBRATE CHECK
Performs the calibration routine but does not change
the calibration values. Prints the signal value with the
current calibration coefficient.
RESET yes/no
Hardware reset by watchdog circuitry, verification
yes/no asked.
SIMULATE TEST_MESSAGE
Sets the fixed, predefined data message as the
transmitted message type for system testing purposes.
See section Message Formats on page 72.
SIMULATE MANUAL_MESSAGE string
User definable data message for system testing
purposes.
SIMULATE OFF
Disables simulation message sending and returns to
normal operation mode.
ELOG clear
ELOG command alone lists the error log contents. The
error log is cleared with the CLEAR parameter.
SET MESSAGE SECOND TYPE
message_number
Selects the message type to be transmitted as the
Second Message.
SET MESSAGE SECOND TYPE MITRAS
Selects the MITRAS Single Base emulation mode for
the Second Message. The data message, message
frames, and polling format are the same as they are in
Vaisala MITRAS Transmissometer.
SET MESSAGE SECOND TYPE
MITRAS_DB
Selects the MITRAS Double Base emulation mode for
the Second Message. The data message, message
frames, and polling format are the same as they are in
Vaisala MITRAS Transmissometer.
SET MESSAGE SECOND TYPE
FD12MSG2
Selects the FD12 message 2 emulation mode for the
Second Message. The data message, message frames,
and polling format are the same as they are in Vaisala
FD12 Visibility Meter.
SET MESSAGE SECOND TYPE
FD12MSG7
Selects the FD12 message 7 emulation mode for the
Second Message. The data message, message frames,
and polling format are the same as they are in Vaisala
FD12P Weather Sensor.
SET MESSAGE SECOND PORT DATA
The Second Message is directed to the Data port.
SET MESSAGE SECOND PORT
MAINTENANCE
The Second Message is directed to the Maintenance
port.
SET MESSAGE SECOND PORT MODULE
(DMX501 only)
The Second Message is directed to the optional
communication module, for example, modem module.
SET MESSAGE SECOND PORT NONE
No Second Message is given to any port (default).
SET MESSAGE ACKNAK ON
The reception of the First Message has to be
acknowledged by the ASCII character ACK (0x06). If no
ACK is received within 500 ms after the transmission of
the last character of the First Message or an ASCII
character NAK (0x15) has been received, the First
message is repeated. The First Message is repeated up
to two times.
SET MESSAGE ACKNAK OFF
The reception of the First Message needs not to be
acknowledged. (default)