Chapter 7 __________________________________________________ Host Computer Commands
VAISALA______________________________________________________________________ 271
0916-095
Combination of OPTS_xxx bits which modify details of timeseries
behavior.
0916-096
These two words allow you to set the breakpoints and slopes that modify
the LOG threshold according to the Clutter-to-Noise ratio of the target.
This makes the LOG threshold behave properly even as the noise floor
becomes elevated due to very strong clutter targets. A value of zero will
restore the RVP900 defaults from the Mf menu.
0916-097
During time series playback, the height recorded with the time series is
used instead of this value.
The default (power-up) values for the above parameters are listed below.
Both the scientific units and the integer-input required by the command to
set up that value are given. Most of these defaults will likely be reasonable
for a wide variety of radars.
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| Flag bits related to timeseries (playback) | XARG 6
|_______________________________________________________________|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| 1 | Offset in deciBels | Slope as 100 * dB/dB | XARGs 7&8
|___|___________________________|_______________________________|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| Melting Height in Meters Above/Below Mean Sea Level | XARG 9
|_______________________________________________________________|
To Next Page
Loading...