5
2.4 Charging your Terminal.
There are two options available to charge your terminal, either through connecting the power
source directly to the terminal or via the terminal base:
i) Connecting base station to power
1� Insert the power cable into the power port on the terminal base�
2� Plug the AC power cord into a wall outlet or a surge protected power board�
3� Place terminal on the base to begin charging�
ii) Alternate charging method
1� Insert the power cable to the power port found on the side of the terminal�
2� Plug the AC power cord into a wall outlet or a surge protected power board�
Note: It is recommended that you charge your terminal through the terminal base as this will
enableyouto quickly return your terminal to charge mode between uses.
To Next Page
Loading...
