Vermes MDS 3200A - Input of Values; Saving Parameter Sets; Retrieving Parameter Sets

VTK‐VS‐BA‐004e‐B|UserManualMDS3200A | Operation
36
6.5 InputofValues
Modificationofparametervaluesissimple.Thenameoftheparameterappearsintheup‐
per,theassignednumericalvalueinthelowerlineofthescreen.Ifthelastdigitbeforethe
decimalpointisflashing,thevaluecanbemodified.

 Increasebyone byarrowpointingupward.
 Correspondingly, thearrowpointingdownwardreducesthevaluebyone.
 Thisarrow shiftsthepositionoftheactivedigittotheright.
 Toshifttheactivepositiontotheleft,usetheleftarrow.
Selectionofothervalues(nonumericalvalues)isperformedsimilarly.

 Usethe
right ortheleft arrowtoswitchbetweenONandOFF.

Aninputmustbeconfirmedby ,tosavethecurrentselection.
Thenthecontrolreturnstothenext‐highermenupoint.

Tocancelwithoutsavingthecurrentselection,press .Inthiscase,thescreenalso
returns
tothenext‐highermenulevel.

IMPORTANTNOTE!(changingnumbers)
Whenmodifyingadigitfrom“1“to“0“,thecursorautomaticallyjumpsonepositiontothe
right(ifpossible).Thevalueinthispositionissetto5,butcanbemodifiedasrequired.
6.6 SavingParameterSets
Tenstoragelocationsareavailabletosavepulseparametersofamenu,togetherwithset‐
tingsforheaterandkeylock.
Step1: OpentheStoreMenuwith[save].
Step2: Selectthedesiredlocationbyarrowkeys.
Step3: Confirmtheselectionbypressing[enter].

IMPORTANTNOTE!
Pressing
[esc]causesthesavingproceduretobeaborted.
6.7 RetrievingParameterSets
Parametercombinationssavedinthesystemcanberecalledanytime.
Step1: Press[recall]toactivatethecorrespondingfunction.
Step2: Selectthedesiredstoragelocationbyarrowkeys.
Step3: Acknowledgetheselectionby[enter].

IMPORTANTNOTE!
Pressing[esc]causestheproceduretobeaborted.

