Vertical SBX IP 320 - Page 101

Hunt Groups 91
SBX IP 320 Features & Operation Guide
The following operation follows the normal operation for the DSS button feature assigned to
"station group".
To re-route queued calls without answer by the supervisor:
1. Assign a flexible button as an {ACD Group} button. The DSS LED of the {ACD Group}
button flashes when there are queued calls.
2. A supervisor presses "No answer reroute code" 564 and destination station number or
{DSS} to reroute the first queued call.
To monitor an agent's conversation at the ACD supervisor station:
1. Call the busy agent and receive a busy tone.
2. Press the {ACD} flexible button.
3. The supervisor can monitor the agent, but will not send audio to the agent.
To Record an agent's conversation at the ACD supervisor station:
1. Call the busy agent and receive a busy tone.
2. Press the {ACD} flexible button.
3. The supervisor can monitor the agent, but will not send audio to the agent.
4. Press the [Two Way Recording] button.
5. When Two Way Record is stopped, the recorded VMIB message is left at the supervisor
station.
To activate ACD-DND manually:
1. Assign {ACD-DND} with ACD-DND feature code [Trans] + 87 + Group NO on station.
2. An ACD member user presses the {ACD-DND} button in order to go into the
ACD-DND mode. The {ACD-DND} button turns steady on when in the ACD-DND
mode.
To deactivate ACD-DND:
Press the illuminated {ACD-DND} button.
Conditions
• The supervisor should assign a flexible button for {ACD}.
[TRANS/PGM] + Flex. BTN + [TRANS/PGM] + 8* + ACD Group No + [HOLD/SAVE]
• The user can see the same group status as seen by the ACD supervisor or by printing
periodically to RS-232C print.