Vertiv Liebert iCOM - Page 6

8.2.6 Network Configuration 127
8.2.7 Web Server Configuration 129
8.2.8 Remote Services Configuration 132
8.2.9 Velocity Protocol Configuration 135
8.2.10 Messaging Configuration 136
8.2.11 BACnet Protocol Setup 141
8.2.12 Modbus Protocol Setup 144
8.2.13 SNMP Protocol Setup 146
8.3 Unity Status Readings 150
8.4 Unity Support Information 151
8.4.1 Configuring Active Networking Settings 152
9 Configuring Auxiliary Devices 155
9.1 Power Monitoring 155
9.1.1 Power Monitoring Device Options 155
9.2 Fluid Temperature Monitoring 156
9.2.1 Fluid Sensor options 156
9.3 Configuring Analog Input Devices 157
9.4 Wired Remote Sensors 157
9.4.1 Wired Remote Sensor Setup Options 158
9.4.2 Wired Remote Sensor Sensor Property Options 159
9.5 Supply Sensors 160
10 Administering Firmware, Settings and Security 161
10.1 Vertiv™ Liebert® iCOM™ Firmware Upgrades 161
10.1.1 Compatibility with Earlier Versions of Vertiv™ Liebert® iCOM™ 161
10.1.2 Updating Vertiv™ Liebert® iCOM™ Control Board Firmware 161
10.1.3 Reverting to Firmware in Dormant Partition 163
10.2 Backing Up and Restoring Control Board Settings 163
10.2.1 Control Board Back Up and Restore Options 163
10.3 Managing Access Permission and Passwords 164
11 Performing Diagnostics 165
11.1 Cooling Unit Status LED 165
11.2 Enabling Manual Mode for Diagnostics 165
11.2.1 Disabling Diagnostics Manual Mode 166
11.3 Diagnosing Evaporator Fan Issues 166
11.3.1 Diagnostics—Evaporator Fan Options 166
11.4 Diagnosing Compressor Circuit Issues 167
11.4.1 Diagnostics—Compressor Circuit Options 167
11.4.2 Resetting High Pressure Alarm Code 168
11.4.3 Resetting Low Pressure Alarm Code 168
11.4.4 Resetting High Temperature Alarm Counter 169
11.5 Diagnosing Electronic Expansion Valve Issues 169
iv
Vertiv™ Liebert® iCOM™Installer/User Guide