Vertiv Liebert iCOM - Page 7

11.5.1 Diagnostics—Electronic Expansion Valve Options 169
11.5.2 Resetting EEV Battery Failure Counter 170
11.6 Diagnosing Vertiv™ Liebert® EconoPhase Issues 170
11.6.1 Diagnostics—Vertiv™ Liebert® EconoPhase Options 170
11.7 Diagnosing Reheat Issues 171
11.7.1 Diagnostics—Reheat Options 171
11.8 Diagnosing Humidifier Issues 171
11.8.1 Diagnostics—Humidifier Options 172
11.9 Diagnosing Digital Output Issues 172
11.9.1 Diagnostics—Digital Output Options 173
11.10 Diagnosing Analog Output Issues 173
11.10.1 Diagnostics—Analog Output Options 173
11.11 Diagnosing Customer Input Issues 173
11.11.1 Diagnostics—Customer Input Options 173
11.12 Diagnosing Water Leak Detection Issues 174
11.12.1 Diagnostics—Water Leak Detection Options 174
12 Customizing the Vertiv™ Liebert® iCOM™ Display 175
12.1 Setting General Display Properties 175
12.1.1 Unit Display Options 175
12.2 Customizing Main Display Views 176
12.2.1 Moving Content 176
12.2.2 Resizing Content 176
12.2.3 Adding and Adjusting Content 177
12.2.4 Removing Content 178
12.3 Customizing Parameter and Field Labels 178
12.3.1 Exporting, Importing and Customizing Labels Using a Text Editor 180
13 Vertiv™ Liebert® iCOM™ Hardware Installation 181
13.1 Return Air Temperature/Humidity Sensor 181
13.1.1 P67: Return Air Temperature—Humidity Board 181
13.1.2 Jumper P3 CANbus Termination 183
13.2 Installing Wired Remote Sensors 184
13.2.1 Setting DIP Switches and Labeling 2T Sensors 184
13.2.2 Terminating the Last Sensor on the CANbus link 186
13.2.3 Installing 2T Sensors in the Racks to Monitor 189
13.2.4 Connect the CANbus Cable and Ground 191
13.3 Installing a Fluid Temperature Sensor 193
13.4 Installing Supply Control Sensors 195
13.4.1 Installing the Supply Air Temperature Sensor 195
13.4.2 Installing Aggregated Supply Air Temperature Sensors 196
13.5 Installing Analog Input Devices 196
13.6 Installing the U2U Network 197
v
Vertiv™ Liebert® iCOM™Installer/User Guide