3-2 Setting the Air Pressure Rev AA
Videojet DataFlex 6420 Operator Manual
To view and set the air pressure on the printer, proceed as follows:
1 Locate the air pressure regulator (Figure 3-1). It is close to the
printhead and connected to the printhead by a 4-mm air line.
2 Read the air pressure displayed on the regulator. It should show the
value as per Table 3-1.
3 If the dial on the regulator does not display the correct value, lift the
air regulator control knob and turn it clockwise to increase the
pressure, or counterclockwise to decrease the pressure.
4 Push the control knob down to lock it in position.
Air Pressure Regulator
Figure 3-1: Air Pressure Regulator
To Next Page
Loading...