71User Manual Visit the ViewZ USA website at https://www.viewzusa.com
CONFIG. /INTELLIGENT ANALYSIS
9. Converse
Deployment Area Settings
Move the cursor to the drawing interface and click to generate a point, move the cursor to draw a line, and
then click to generate another point. This is how a line is generated. In this way, connue to draw lines to form
any shape, and right-click to nish line drawing, as shown in Figure 6-27.
Figure 6-27 Deployment Area Setting Interface
Note
• A drawn line cannot cross another one, or the line drawing fails.
• Any shape with 32 sides at most can be drawn.
• The quanty of deployment areas is not limited yet and will be described in future when a limit is applied.
To Next Page
Loading...
Need help?
General
