Vox Dynamic Looper

36
VOX Dynamic Looper Owner's manual
Πod: MODULATION
This effect lets you use the control pedal to vary the sound
from a subtle chorus effect through deep flanging.
• EDIT knob: Specifies the LFO rate. The LFO will
synchronize with the tempo.
8-1:

x8 (8 measures) 3-16:  ( dotted eighth notes)
4-1:

x4 (4 measures) 1-6:  3 (quarter note triplets)
2-1:

x2 (2 measures) 1-8:  (eighth notes)
1-1:

(1 measure = whole note) 1-12: 3 (eighth note triplets)
3-4:  (three beats = dotted half note) 1-16:  (16th notes)
1-2:  (two beats = half note) 1-24: 3 (16th note triplets)
3-8:   (one and a half beats) 1-32:  (32nd notes)
1-3:  3 (half note triplets) 1-64:  (64th notes)
1-4:  (1 beat = quarter note)
• Control pedal: Controls the depth of the effect. Advancing
the pedal (increasing the value) produces a flanger effect;
returning the pedal (decreasing the value) produces a
chorus effect.
FLt: FILTER
This is a filter effect that lets you use the control pedal to
control the cutoff frequency.
• EDIT knob: Selects the filter type.
HPF: High pass filter
bPF: Band pass filter
LP1: Low pass filter 1
LP2:Low pass filter 2 (a steeper low pass filter)
• LOOP FX button + EDIT knob: Adjusts the resonance.
• Control pedal: Controls the filter’s cutoff frequency.
dLy: DELAY
This is a tempo-synchronized delay. Advancing the control
pedal to increase the feedback will produce oscillation as can
occur on an analog delay unit.
• EDIT knob: Switches the delay time. Settings other than
short delay will synchronize to the tempo.
Sho: short delay 1-6: 3 (quarter note triplets)
1-64: (64th notes)
3-16:  ( dotted eighth notes)
1-32:  (32nd notes) 1-4:  (1 beat = quarter note)
1-24: 3 (16th note triplets) 1-3:  3 (half note triplets)
1-16:  (16th notes) 3-8:  (one and a half beats)
1-12:3 (eighth note triplets)
1-2:  ( two beats = half note)
1-8:  (eighth notes)
• Control pedal: Controls the feedback amount and the
overall volume balance.