Vox Dynamic Looper

41
Auto Power-Off function
Auto Power-Off function
The Dynamic Looper has an Auto Power-Off function that
automatically turns off the power when four hours have
elapsed since the most recent or user input.
Note: Even if an there hasn’t been any user input, the Auto
Power-Off function will not engage if there is audio input
present at the input jack.
Note: When the Dynamic Looper is shipped from the
factory, the Auto Power-Off function is enabled.
Disabling the Auto Power-Off
function
Here’s how to disable the Auto Power-Off function.
1.TurntheDynamicLooper’spoweroff.
2.WhileholdingdowntheSTOPMODEbuttonandthe
CANCELbutton,turnthepoweron.
The program/value display will indicate “diS,” and then
the Dynamic Looper will start up in the normal way.
Enabling the Auto Power-Off function
Here’s how to re-enable the Auto Power-Off function after
you’ve disabled it.
1.TurntheDynamicLooper’spoweroff.
2.WhileholdingdowntheSTOPMODEbuttonandthe
WRITEbutton,turnthepoweron.
The program/value display will indicate “EnA,” and then
the Dynamic Looper will start up in the normal way.
Note: The enabled/disabled state of the Auto Power-Off
function is remembered even when you turn off the
power.