Mobile Generator Disassembly/Assembly
wc_tx000575gb.fm 107
Continued from the previous page.
9.15.6 Add a small amount of epoxy to the diode holder.
9.15.7 Insert the diode (e) into the holder. Red marking faces to the right.
9.15.8 Cut (f) any excess wire from the new diode.
9.15.9 Add heat sinks (g) (alligator clips are shown for this purpose).
9.15.10 Solder (h) the new diode to the existing (old) wires.
9.15.11 Rotate the engine and repeat the soldering procedure for each diode.
9.15.12 Reassemble the machine.
To Next Page
Loading...
