Disassembly/Assembly Mobile Generator
86 wc_tx000575gb.fm
9.6 Preparing Unit for Generator Removal
See Graphic: wc_gr003321
9.6.1 Remove the roof. See section Removing Roof.
9.6.2 Remove the screws that secure the air filter assembly and set the air
filter assembly off to the side.
9.6.3 Remove the cover to the VSS box.
9.6.4 Cut the wire tie (a) that secures the wiring to the engine.
9.6.5 Disconnect the ground strap (b) between the generator and the frame.
9.6.6 Disconnect the ground strap (c) between the engine and the control
panel enclosure.
9.6.7 Disconnect the fuel line (d) from the fuel filter.
9.6.8 Disconnect the wires from the Automatic Voltage Regulator (AVR) (e):
blue from term 1, yellow from term 3, blue-white from term 3A, green
from term 4, red from term 5, and black from term 5C. Cut the wire ties
that secure the wires.
9.6.9 Disconnect the other AVR wires (f): red wire from the lighter gauge
blue wire, blue-white wire at the connector to the lighter gauge blue-
white wire.
9.6.10 Cut the wire tie then disconnect the connector (g) holding wire L1 to
wire #1 from the generator. Also cut the wire tie and disconnect the
connector holding wire L3 to wire #9 from the generator.
9.6.11 Cut the wire ties (h) that secure the rest of the generator wires.
9.6.12 Disconnect the generator wires from the VSS.
9.6.13 Remove the screws that secure the door hinges (i) and remove the
hinges.
9.6.14 Lift and rotate the control panel enclosure (j) approximately 90° to
obtain access to the generator. Support the control panel enclosure in
this position.
To Next Page
Loading...
Need help?
General
