Mobile Generator ECM Background Information
wc_tx000713gb.fm 31
G 25, G 50, G 85 (9310) Cold Weather and Custom Generators
The display shows the status of the oil pressure sender.
If the oil pressure sender has failed, the time of the failure
will be displayed. The time of the failure will be included
in the display until the generator has been shut down and
remains shutdown for a period of approximately two min-
utes.
The display shows the status of the engine coolant tem-
perature sender. If the coolant temperature sender has
failed, the time of the failure will be displayed. The time of
the failure will be included in the display until the genera-
tor has been shut down and remains shutdown for a
period of approximately two minutes.
ECM Display Description
The display shows the total time, in 1/10 hour incre-
ments, that the engine has been run. New machines, or
machines with new ECMs, will read 0.0 or “No Data”
because the engine has not been run for more than 1/10
of an hour.
The display shows the amount of time left until service on
the machine is required. To reset the timer to 250 hours,
hold the Hours/Reset toggle switch in the up position until
all the screens have been scrolled through twice.
The display shows the date and job number data regard-
ing the ECM manufacture.
The display shows the AC configuration as determined
by the position of the Voltage Selector Switch (VSS). If
the machine is not running, the display reads “Unknown”.
The ECM displays this screen to let the operator know
that the alternator protection system has been enabled
or disabled.
Oil Pressure Sender
OK
Water Temp Sender
OK
Running Time
0.1 Hours
Time to Service
250.0 Hours
SW Rev. x/x/x (date)
Job No. 123456
AC Configuration
Alt Protection
Enabled
To Next Page
Loading...
Need help?
General
