Usage
2.1 Intended Use
10
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
2 Usage
2.1 Intended Use
This machine is intended for the illumination of outdoor areas. This machine
is also intended for the purpose of supplying electrical power to connected
loads. For more information, see Generator on page 97 for the output volt-
age and frequency of this light tower, and for the maximum output power
limit of this light tower.
2.2 Unintended Use
This machine has been designed and built strictly for the intended use de-
scribed above. Using the machine for any other purpose could permanently
damage the machine or seriously injure the operator or other persons in the
area. Machine damage caused by misuse is not covered under warranty.
The following are some examples of misuse:
• Connecting a load that has voltage and frequency requirements that are
incompatible with the machine output
• Overloading the machine with a device that draws excessive power dur-
ing either continuous running or start-up
• Operating the machine in a manner that is inconsistent with all federal,
state, and local codes and regulations
• Using the machine as a hoist, or hanging items from the tower
• Using the machine as a ladder, support, or work surface
• Operating the machine outside of factory specifications
• Operating the machine in a manner inconsistent with all warnings found
on the machine and in the operator’s manual
2.3 Residual Risks
This machine has been designed and built in accordance with the latest
global safety standards. It has been carefully engineered to eliminate haz-
ards as far as practicable and to increase operator safety through protective
guards and labeling.
However, some risks may remain even after protective measures have been
taken. They are called residual risks. On this machine, they may include ex-
posure to:
• Heat, noise, exhaust, and carbon monoxide from the engine
• Heat from the lights
• Ultraviolet radiation from the lights
• Glare from the lights (lights may blind drivers of nearby motor vehicles if
the lights are incorrectly positioned)
• Fire hazards from improper refueling techniques
• Fuel and its fumes
• Electric shock and arc flash
To Next Page
Loading...
