Maintenance
8.5 Maintaining the Trailer
80
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
Overview
Inspect the machine before each use. A thorough inspection helps to identify
mechanical faults or potentially unsafe operating conditions. Correct these
problems before operating the machine.
External inspection
Perform an external inspection of the machine. Check for:
• External damage (dents, cracks, broken door latches, etc.)
• Loose or missing fasteners
• Loose or missing parts
• Cut or worn insulation on electrical cords
• Damaged light fixtures or lamps
• Fluid leaks
• Restricted air flow at the engine exhaust
• Problems with the trailer (if equipped, see Maintaining the Trailer on
page 80)
Internal inspection
Open the access doors on both sides of the machine. Check for:
• Damage to control panels, switches, or convenience receptacles
• Loose or missing fasteners
• Loose or missing parts
• Loose or damaged hoses
• Fluid leaks
• Rags, containers, or other debris inside the cabinet
8.5 Maintaining the Trailer
When
Daily
Tires
• Keep tires inflated to the proper pressure as shown on the tire sidewall.
• Check tread periodically for wear.
• Replace tires as required.
Wheels
• Check that lug nuts holding wheels are tight.
• Replace any missing lug nuts immediately.
Axle hubs
• Grease axle hubs using a good wheel-bearing grease.
To Next Page
Loading...
Need help?
General
