Maintenance
8.9 Replacing/Removing Lamps
84
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
2. Place all electrical switches in the OFF position.
3. Disconnect the black negative (-) battery cable from the battery.
4. Disconnect the red positive (+) battery cable from the battery.
Maintaining battery condition
• Follow the battery manufacturer’s maintenance recommendations.
• Keep battery terminals clean and connections tight.
• When necessary, tighten the cables and grease the cable clamps with
petroleum jelly.
• Maintain the battery at full charge to improve cold weather starting.
8.9 Replacing/Removing Lamps
WARNING
Burn hazard
Lamps become extremely hot in use.
► Allow lamps and fixtures to cool 10 to 15 minutes before handling.
WARNING
Personal injury hazard
Ultraviolet radiation from the lamps can cause serious skin and eye irritation.
► Use only undamaged lamps.
► Use the lamps only with undamaged original equipment lenses and fix-
tures.
WARNING
Explosion hazard
Grease or oil residue on the lamp can cause the outer jacket to burst or
shatter. Hot flying glass particles can cause personal injury, property dam-
age, burns, or fire.
► Do not operate any lamps with lenses that are cracked, damaged, or
missing.
► Do not scratch the lamp or subject the lamp to excess pressure.
► Wear eye protection and gloves when removing or replacing lamps.
Requirements
• Machine shut down
• Light circuit breakers turned OFF
To Next Page
Loading...
Need help?
General
