Factory-Installed Options
Overview 11.1
93
[en-US] | 02/2023 | 5100065071 | LTV 4L/6L | Operator’s Manual
11 Factory-Installed Options
11.1 Overview
This machine may be equipped with one or more of the following factory-in-
stalled options. To verify if any of these options are installed on your ma-
chine, contact Wacker Neuson America Corporation at 1-800-770-0957. A
nameplate listing the model number, item number, and serial number is at-
tached to each unit. Please have this information available when contacting
Wacker Neuson America Corporation.
The illustrations shown in this chapter represent typical installations. The
factory-installed options on your machine may look different.
11.2 Cold Weather Package
The cold weather package includes the engine block heater, battery blanket,
oil pan heater, and 60/40 or cold weather coolant. The Kohler cold weather
package also includes the piston fuel pump.
11.3 Oil Pan Heater
Fig.48: Oil pan heater
Cold, thick engine oil does not flow freely and may cause engine starting dif-
ficulties. An oil pan heater (1) installed on the engine oil pan keeps the oil
warm and flowing. Heat from this electrical device warms the supply of en-
gine oil contained in the pan while the machine is not in use. Plug the cord
into a 120V power supply.
11.4 Engine Block Heater
Fig.49: Engine block heater
The engine block heater (1) includes a block heater with a cord. The function
of the block heater is to heat the engine coolant/engine block to improve
cold-weather engine starting. Plug the cord into a 120V power supply.
11
To Next Page
Loading...
Need help?
General
