Operation
7.13 Auto Mode (Auto Start/Stop) (if equipped)
70
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
Fig.41: Maintenance timer screen
2. Press and hold the Stop button (2) for 10seconds. The timer resets.
7.13 Auto Mode (Auto Start/Stop) (if equipped)
The engine controller is capable of automatically starting/stopping the en-
gine.
A scheduled run will begin only if the controller is in Auto Mode (LED is lit)
with no shut-down alarm present. If the controller is in Stop/Reset Mode or
Manual/Start Mode when a scheduled run begins, the engine will not start.
However, if the controller is set to Auto Mode during a scheduled run, the
engine will start.
If the engine is running “Off Load” in Auto Mode and a scheduled run config-
ured to “On Load” begins, the set is placed “On Load” for the duration of the
schedule.
Front panel configuration
This configuration mode allows the operator to configure the module through
its display without the use of the Deep Sea computer software.
Use the controller’s buttons to navigate through the menu and change the
parameters.
Fig.42: Controller buttons
To Next Page
Loading...
Need help?
General
