Storage
Long-Term Storage 10.1
91
[en-US] | 02/2023 | 5100065071 | LTV 4L/6L | Operator’s Manual
10 Storage
10.1 Long-Term Storage
NOTICE
Allowing the battery to freeze or completely discharge is likely to cause per-
manent damage.
► Periodically charge the battery while the machine is not in use.
► In cold climates, store and charge the battery indoors or in a warm loca-
tion.
When
Prepare your machine for extended storage if it will not be operated for
30days or more.
Overview
Extended storage of equipment requires preventive maintenance. Perform-
ing these steps helps to preserve machine components and ensures the ma-
chine will be ready for future use. While not all of these steps necessarily ap-
ply to this machine, the basic procedures remain the same.
Preparing for storage
Perform the procedures below to prepare your machine for storage.
• Complete any needed repairs.
• Replenish or change oils (engine, exciter, hydraulic, and gearcase) per
the intervals specified in the Periodic Maintenance Schedule table.
• Grease all fittings and, if applicable, repack bearings.
• Inspect engine coolant. Replace coolant if it appears cloudy, is more
than two seasons old, or does not meet the average lowest temperature
for your area.
• If your machine has an engine equipped with a fuel valve, start the en-
gine, close the fuel valve, and run the engine until it stops.
• Consult the engine owner’s manual for instructions on preparing the en-
gine for storage.
Stabilizing the fuel
After completing the procedures listed above, fill the fuel tank completely
and add a high-quality stabilizer to the fuel.
• Choose a stabilizer that includes cleaning agents and additives designed
to coat/protect the cylinder walls.
• Make sure the stabilizer you use is compatible with the fuel in your area,
fuel type, grade, and temperature range. Do not add extra alcohol to fu-
els which already contain it (for example, E10).
10
To Next Page
Loading...
Need help?
General
