Operation
7.10 Machine Monitoring
66
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
5. Allow the engine to warm up before operating the lights.
Operating the lights
1. Turn on the main circuit breaker (1).
Fig.38: Starting, operating, and stopping controls
2. Turn on individual circuit breakers (3) one at a time.
Notes
• Metal halide floodlights require a warm-up time of 5–15minutes before
they reach full brightness.
• After turning the lights off, a cool-down time of 10minutes is necessary
before they can be turned on again.
Stopping the machine
NOTICE
Failure to turn off lights may cause damage to the electrical system.
► Turn off the lights before stopping the engine.
1. Disconnect all loads from the machine.
2. Turn the circuit breakers (1) off.
3. Press the Stop button (5) to de-energize the fuel solenoid.
7.10 Machine Monitoring
Engine and generator information is displayed on the LCD panel. The user
can scroll through the screens to monitor machine parameters.
To Next Page
Loading...
Need help?
General
