Safety
Safety Guidelines for Maintenance 3.5
15
[en-US] | 02/2023 | 5100065071 | LTV 4L/6L | Operator’s Manual
After use
• Stop the engine when the machine is not being operated.
• Ensure that the machine will not tip over, roll, slide, or fall when not being
operated.
• Store the machine in a clean, dry location out of the reach of children.
• Lower the tower when not in use, or if high winds or electrical storms are
expected in the area.
• The lamps become extremely hot in use! Allow the lamp and fixture to
cool 10–15 minutes before handling.
3.5 Safety Guidelines for Maintenance
Before servicing or maintaining the machine, see Safety Guidelines for Op-
erating the Machine on page 13.
Precautions
Follow the precautions below when servicing or maintaining the machine.
• Read and understand the service procedures before performing any ser-
vice to the machine.
• Personnel servicing or maintaining the machine must be familiar with the
associated potential risks and hazards.
• Turn off the machine before performing maintenance or making repairs.
• Remain aware of the machine’s moving parts. Keep hands, feet, and
loose clothing away from the machine’s moving parts.
• Before servicing the light tower, make sure the engine is turned off, the
circuit breakers are open (off), and the negative terminal on battery is
disconnected. Do not perform even routine service (oil/filter changes,
cleaning, etc.) unless all electrical components are shut down.
• Always turn off light circuit breakers and shut down engine before dis-
connecting light fixtures or changing light bulbs.
Machine modifications
When servicing or maintaining the machine:
• Use only accessories/attachments that are approved by WackerNeuson.
• Do not defeat safety devices.
• Do not modify the machine without the express written approval of
WackerNeuson.
Replacing parts and labels
• Replace worn or damaged components.
• Replace all missing and hard-to-read labels.
3
To Next Page
Loading...
Need help?
General
