Maintenance
Chassis/safety devices
BA RD24_RD27 en 04
133
Checking the seat contact switch when the machine is stationary
Start the diesel engine [1].
Stand up from the driver's seat (looking forwards). Be sure of your
footing and hold on tight.
To release the parking brake: Press the parking brake switch [2].
Briefly push the driving lever [3] forwards.
a
The machine does not start moving: The seat contact switch is
working properly.
a
The machine starts moving: The seat contact switch is not working
properly.
After the check: Return the driving lever [3] to the 0 position and apply
the parking brake [2].
NOTE
If the seat contact switch does not work, it must be tested and
repaired without delay. The machine must not be operated until
this has been completed. Contact customer service!
To Next Page
Loading...
Need help?
General
