Wacker Neuson RD24 - Mounting;Dismounting

Auxiliary equipment
HAMM line spreader
BA RD24_RD27 en 04
213
Instruments and controls
1
3
2
1 3 2 4
[1] Operating mode switch [2] Drum preselection switch
[3] Dynamic compaction system
switch
[4] Compaction system/chip
spreader switch
6.06.02 Mounting/Dismounting
WARNING
High own weight of the chip spreader!
Serious injuries or death caused by crushing or getting caught during
assembly.
■
Perform installation work on firm ground (flat, stable, horizontal).
■
Carry out fitting work only when the engine is stopped.
■
Use suitable load suspension and hitching gear with an adequate
loading capacity.
■
Do not step underneath suspended loads.
■
Mount only when the storage tank is empty.
5
2 4
3
1
NOTE
Use appropriate lifting devices and hoisting equipment.
Observe weight (see type plate of chip spreader).