Wacker Neuson RD24 User Manual

Auxiliary equipment
Edge pressing and cutting device (KAG)
208
BA RD24_RD27 en 04
Press and hold the switch [2] or foot switch [3] for water sprinkling.
a
Roller drum and KAG sprinkling will be performed as long as the
switches are being pressed.
Close the stop cock [4].
a
The KAG sprinkler is disconnected from the water sprinkler of the
roller drums.
KAG sprinkler with switch
NOTE
The optional switch allows to set KAG sprinkling to on or off.
5
Requirement: The stop cock [4] is open.
Press the switch [5] at the top.
a
The KAG sprinkler is connected to the water sprinkler of the roller
drums.
Press the switch [5] at the bottom.
a
The KAG sprinkler is disconnected from the water sprinkling of the
roller drums.
6.05.05 Maintenance
Basic maintenance tasks
■
Remove dirt deposits.
■
Replace damaged and/or non-readable warning signs.
■
Check that the screw connections on console, levers, cutting disc and
pressing roll are tight.
Maintenance overview
Every 250 operating hours
250 h
Cleaning sprinkler nozzles
Lubricating KAG cylinder bolts
Lubricate the KAG lever bearing

Wacker Neuson RD24 Specifications

General

Brand	Wacker Neuson
Model	RD24
Category	Construction Equipment
Language	English