Operation
Switching the turn signals/hazard warning lights on and off
80
BA RD24_RD27 en 04
3.12 Switching the turn signals/hazard warning lights on and off
NOTE
To control the indicator lights and warning flashers, use the
operator control panel.
The warning flashers can also be switched on when the
electrical system is off. For the indicator lights, the electrical
system needs to be on.
Left-hand/right-hand turn indicating
Requirement: Electrical system is ON.
Press the switch [1] for left-hand indicating .
Press the switch [2] for right-hand indicating.
a
The corresponding indicator light [3/4] is flashing: Flashing light on.
a
For versions with add-on equipment:
The corresponding switch [1/2] is flashing: Flashing light on.
Press the switch [1/2] again.
a
Indicator lights [3/4] off: Flashing light off.
a
For versions with add-on equipment:
Switch [1/2] unlit: Flashing light off.
Switching the warning flashers on/off
Press switch [5].
a
Indicator light [6] flashing: Warning flashers on.
a
For versions with add-on equipment:
Switch [5] flashing: Warning flashers on.
Press switch [5] again.
a
Indicator light [6] is off: Warning flashers off.
a
For versions with add-on equipment:
Switch [5] unlit: Warning flashers off.
NOTE
If the light bulb in one of the direction indicators is defective,
the indicator lights/switches flash rapidly. To guarantee road
safety, the defective light bulb must be replaced.
To Next Page
Loading...
Need help?
General
