Wacker Neuson RD24 - Replacing;Adjusting Type Scrapers

Maintenance
Transmission
152
BA RD24_RD27 en 04
Folding scraper
3
2
2
1 1 2 2
3
Exchanging the scraper
Switch off diesel engine and remove ignition key.
Turn stop lever [3] to 0 position.
Move the scraper [1] away.
Loosen clamp connection [2].
Replace scraper [1] by a new one.
Tighten clamp connection [2].
4.06.04 Replacing/adjusting type scrapers
NOTE
If they are worn-out to such an extent that sticking dirt is not
removed from the roller drums/tyres during work any longer,
the scrapers must be readjusted or replaced.
NOTE
To install a new scraper, be sure to place the screws for the
clamp connection into the lowest positions of the elongated
holes.
3
2 1 2 2 21
Readjusting/replacing scrapers
Switch off diesel engine and remove ignition key.
Turn stop lever [3] to 0 position.
Move the scraper [1] away.