Auxiliary equipment
HAMM line spreader
BA RD24_RD27 en 04
215
NOTICE
Sticking gritting material!
Blocked spreader shaft, material damage or destruction of the driving
elements.
■
Completely open the spreader apertures before switching on the
spreader rotor.
■
With the machine is at a standstill, only allow the spreader rotor to
start with a low speed, and increase to working speed after a short
time.
■
Set the spreader apertures to the working cross-section.
Adjusting the shut-off slider
Depending on the size of the spreader openings [1], more or less gritting
material will flow out of the storage tank. Grit grain size and discharge
quantity exert an influence on the opening cross-section to be selected.
Use the shut-off slider [2] to adjust the openings in the gritting bottom.
Set the shut-off slider [2] to the MIN position.
a
The spreader openings [1] are closed.
Gradually move the shut-off slider [2] towards the MAX position.
a
The spreader openings [1] are opened gradually.
a
Use the adjustable stop [4] at the scale [3] to repeat an opening
setting already determined beforehand.
When spreading operations are complete, close the spreader
openings (shut-off slider to MIN position) to prevent more gritting
material from flowing out.
To Next Page
Loading...
