6 Notes about this Documentation WAGO-I/O-SYSTEM 750
750-461 2AI Pt100/RTD
Manual
Version 1.4.1
Pos: 14 /Serie 750 (W AGO-I/O-SYSTEM)/Hinweise zur Dokumenta tion (alte Struktur) /Hinweise/Achtung: Hinweis zur Dokumenta tion I/O-Module 750-xxxx @ 4\mod_12 37986979656_21.doc x @ 29023 @ @ 1
The I/O module 750-461 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus coupler or
controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com
.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
Pos: 15.1 /Alle Serien ( Allgemeine Module)/ Überschriften/Ebene 2/ Urheberschutz - Über schrift 2 @ 23\mod_1435647 042188_21.doc x @ 184808 @ 2 @ 1
1.2 Copyright
Pos: 15.2 /Alle Serien ( Allgemeine Module)/ Rechtliches, Allge meines/Urheberschut z ausführlich @ 4\mod_123 5565145234_21.doc x @ 27691 @ @ 1
This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany.
Non-observance will involve the right to assert damage claims.
Pos: 15.3 /Dokumenta tion allgemein/Glied erungselemente/---Sei tenwechsel--- @ 3\mod_12211 08045078_0.docx @ 21810 @ @ 1
To Next Page
Loading...
Need help?
General
