Wallace Perimeter Security SPEEDGATE - Page 134

134
wallaceperimetersecurity.comPhone: 866.300.1110
SPEEDGATE SEMI-ANNUAL MAINTENANCE CHECKLIST
4-SPEEDGATE SEMI-ANNUAL (EVERY SIX MONTHS)
MAINTENANCE CHECKLIST
Checked Good Needs
Aenon
N/A
2. Lubricate all revolving parts (every 10,000 cycles or
six months). Recommended gate hinge lubricant:
Castrol Pyroplex® Protecon ES, a synthec
lithium complex grease. Grease the gate hinge
opening leading to the pin on the top and on the
boom, using a grease gun. Locate the Zerk ng
(grease gun end nipple), and squirt grease into the
opening(s) unl it ows from the bearing. Wipe
away any excess grease with a paper towel or shop
rag.
While it is highly important to inspect the
gate hinges for adequate lubricaon every six
months/10,000 cycles, it is of equal importance to
AVOID EXCESSIVE LUBRICATION. Too much grease
being forced into a gate hinge can cause blockage
and damage to the internal rolling elements. If
exisng lubricaon levels appear adequate, and
there is no apparent binding or noise in proximity
to the hinges, further lubricaon is unnecessary.
3. Inspect fastenings that use bolts and nuts,
specically those of revolving elements.
4. Clean the photo eye faces with a so, clean, dry
cloth.
5. Check the operaon of the photo eyes and the gate
edges.
6. Check the movement of the gate:
6.1 Make sure that the fully closed posion is
correct. Adjust drawbars and/or electronic
limits as needed.
6.2 Make sure that the fully open posion is
correct. Adjust drawbars and/or electronic
limits as needed.
6.3 Ensure gate is moving smoothly.
Comments/Recommendaons: