SPEEDGATE Installation and Maintenance Manual Revision 1 - MAY 2023
7
READ THIS FIRST!
READ THIS FIRST!
Important Informaon
Foreword
THIS MANUAL SHOULD BE READ CAREFULLY PRIOR TO INSTALLING THE SPEEDGATE AND/OR PLACING
IT INTO OPERATION�
This manual describes how the SpeedGate can safely be installed, used and maintained. The manual has
been wrien for the use of persons responsible for the installaon and maintenance of the SpeedGate.
The funcon of the Wallace Perimeter Security SpeedGate is to allow selecve access.
Make sure that the SpeedGate is clearly marked as a vehicular access control system, not
intended for pedestrian use.
Wallace Perimeter Security is not liable for damage arising from any manner of use of the SpeedGate.
Children must never be allowed to play on or around the gate.
The Wallace Perimeter Security Gate System is applicable to a Class I, Class II, Class III
or Class IV Gate System, and may only be installed at locaons meeng the UL 325
denions. Refer to “Applicaon: Idenfying Gate System Category and Usage Class”
on page 21.
The following denions have been extracted from the Underwriters Laboratories (UL)
325 Standards for Door, Drapery, Gate, Louver, and Window Operators and Systems.
They need to be reviewed by both the designer of the system and the installer in order
to make an accurate determinaon as to the appropriate classicaon of the gate site.
The Wallace Perimeter Security Gate System is designed and intended for Class I through
Class IV systems.
ENTRAPMENT:
The condion when an object is caught or held in a posion that increases the risk of
injury.
EXTERNAL ENTRAPMENT PROTECTION DEVICE:
A device, examples being an edge sensor, a photoelectric sensor, or similar entrapment
protecon device, which provides protecon against entrapment when acvated and is
not incorporated as a permanent part of an operator.