Wallace Perimeter Security SPEEDGATE - Photo Eye Installation

70
wallaceperimetersecurity.comPhone: 866.300.1110
PHOTO EYE INSTALLATION
Photo Eye Installaon
Through-beam type photo eyes are shipped pre-wired and terminate into the Post Terminaon connecon
board located in the Primary Column. Through-beam sensors have a transmier (emier) and a receiver,
and trigger whenever the beam between the two is interrupted.
For installaon of other photo eye types (e.g., retro-reecve), follow the manufacturer’s instrucons.
The best way to ensure a quality installaon is to employ a professional installer experienced with
photoelectric sensors.
All entrapment safety devices, including photo eyes, must be installed prior to seng the gate limits.
Deacvate gate during installaon.
Figure 14. Photo Eye Column Mounng
The SpeedGate is shipped with one set
of through-beam type photo eyes.
If a higher safety level is required, the
SpeedGate can be equipped with two
sets of photo eyes.