Wallace Perimeter Security SPEEDGATE - End User Briefing Instructions

SPEEDGATE Installation and Maintenance Manual Revision 1 - MAY 2023
137
END USER BRIEFING INSTRUCTIONS
End User Brieng Instrucons
The following instrucons regarding intended operaon of the gate shall be provided to the End User. This
is to be done by the installer as a required part of the installaon procedures.
To reduce the risk of severe injury or
death:
READ AND FOLLOW ALL OF THESE
INSTRUCTIONS.
1. Ensure the installer of the SpeedGate has provided the End User with a complete review, demonstraon
thereof, and supporng documentaon of the following:
a. A complete copy of the Installaon Manual, which will include mechanical and electrical drawings
and instrucons for the proper operaon and service of the gate system.
b. The normal Sequence of Operaon as to how the Gate will behave in both the opening and closing
cycles:
i. When a controlled open command is given the gate panels begin to move from the closed
posion.
ii. The gate panels will accelerate to the maximum operang speed unl the gate panels reach
the pre-open posion.
iii. At the pre-open posion (factory set), the gates will decelerate and come to a controlled stop
at the fully open posion.
iv. Aer receiving a controlled close command or elapse of the mer-to-close, the gate panels
will move from the open posion to the close posion.
v. The gate panels will accelerate to the maximum operang speed unl they have passed the
pre-open posion.
vi. At the pre-closed posion, the gate panels will decelerate unl they come to a fully closed
posion.
c. The Obstrucon Detecon Devices and how the Gate will behave should any of these devices
encounter an obstrucon. This must include the proper steps to take following both a “So
Shutdown” and a “Hard Shutdown”.
d. The electrical (on/o) disconnect within the electrical controls enclosure.
e. The manual disconnect / mechanical drive; how to properly use it and return the system back to
normal operaon following use of the manual disconnect.
2. Never let children operate or play with gate controls, or play in the vicinity of the Gate. If a remote
control is provided with this system, always keep it away from children.