Wallace Perimeter Security SPEEDGATE - Warning Signs

40
wallaceperimetersecurity.comPhone: 866.300.1110
INSTALLER AND USER SAFETY CONSIDERATIONS
Warning Signs
The hazard warning signs provided with the SpeedGate are mounted immediately adjacent to the
SpeedGate on both sides of the opening. Two English language warning signs, and two French language
warning signs (both ocial languages in Canada), are provided with each SpeedGate shipment, for a total
of four signs. In Canada, mount all four signs. (In non-bilingual jurisdicons, a minimum of two signs are
to be provided for eld installaon; one per opening side.)
The four (4) warning signs provided with this system must be installed where visible in the area of the gate
but not ON the gate. One is to be installed on each side of the gate and on either side of the gate opening.
Each sign must be clearly visible to persons located on the side of the gate on which the warning sign is
installed. These warning signs will be securely aached and it is a UL 325 requirement to keep them visible
and securely mounted.
The signs are to be installed NEAR the gate so they are visible from each side of the gate and should NOT
be installed ON the gate since they should be seen whether the gate is fully open or fully closed. Refer to
“Figure 6.1. Install Signage Near (not on) Gate” on page 41. Specic locaons shall be determined by
the gate installer based on the parcular circumstances for each installaon.
Figure 6. Warning Signs - Panneaux d’averssement