Wascomat Clarus Control SU620 - Page 112

112
Programme unit
Temperature in °C
Here you determine if all temperatures are to be
shown in °C or °F.
If you answer Yes (Y):
All temperatures will be shown in °C.
If you answer No (N):
All temperatures will be shown in °F.
ADJUST SPIN SPEED ALLOWED. Y
DISPLAY REMAINING TIME Y
DISPLAY ACTUAL TEMPERATURE Y
DISPLAY ACTUAL SPEED Y
MACHINE NOT HEATED N
TEMPERATURE CONTROL OF WATER Y
TEMPERATURE IN °C Y
REPEAT PROGR. MODE QUESTION N
LOCKED STANDARD WASH PROGRAMS N
LEVELQUICKCOOL-DOWN 175
LEVEL UNBALANCE 0
LEVEL LOW 135
LEVEL MEDIUM 150
LEVEL HIGH 175
MIDDLETEMPERATURECOOL-DOWN70°C
Y/N
Answer Yes (Y) or No (N).
Press .
Repeat program mode question
Here you determine whether you (or the user) will be
given the chance to select either Standard or Ad-
vanced mode for each new program module you are
programming, if you start programming in Standard
mode.
If you answer Yes (Y):
You can select either Standard or Advanced
mode for each new program module you pro-
gram.
If you answer No (N):
All modules must be programmed using either
Standard mode or Advanced mode consistently,
whichever is selected when you begin program-
ming.
DISPLAY REMAINING TIME Y
DISPLAY ACTUAL TEMPERATURE Y
DISPLAY ACTUAL SPEED Y
MACHINE NOT HEATED N
TEMPERATURE CONTROL OF WATER Y
TEMPERATURE IN °C Y
REPEAT PROGR. MODE QUESTION N
LOCKED STANDARD WASH PROGRAMS N
LEVELQUICKCOOL-DOWN 175
LEVEL UNBALANCE 0
LEVEL LOW 135
LEVEL MEDIUM 150
LEVEL HIGH 175
MIDDLETEMPERATURECOOL-DOWN70°C
DEFAULT MOTOR ON TIME 0:12
Y/N
Answer Yes (Y) or No (N).
Press .