Wascomat Clarus Control SU620 - Page 128

128
Programme unit
HEATING RELAY ON IF NOT HEATED Y
TEMPERATURE INCREASE ALLOWED Y
LEVEL EMPTY 90
LEVEL OVERFILL 200
PAUSE TEST LEVEL 0
PAUSETESTTEMPERATURE -18°C
DEFAULT TEMPERATURE HYSTERIS 4 °C
TEMPERATURESTEPINCOOL-DOWN 4°C
DEFAULT LOW EXTRACT TIME 00:00
DEFAULT MEDIUM EXTRACT TIME 00:00
DEFAULT HIGH EXTRACT TIME 00:00
DEFAULT DRAIN TIME 00:00
DEFAULT DISTR. TIME 00:00
DO UNBALANCE MEASUREMENT N
DRAIN OPEN DELAY 0:13
START EXTRACT TIME 00:30
1 2 3
4 5 6
7 8 9
0
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
HEATING RELAY ON IF NOT HEATED Y
TEMPERATURE INCREASE ALLOWED Y
LEVEL EMPTY 90
LEVEL OVERFILL 200
PAUSE TEST LEVEL 0
PAUSETESTTEMPERATURE -18°C
DEFAULT TEMPERATURE HYSTERIS 4 °C
TEMPERATURESTEPINCOOL-DOWN 4°C
DEFAULT LOW EXTRACT TIME 00:00
DEFAULT MEDIUM EXTRACT TIME 00:00
DEFAULT HIGH EXTRACT TIME 00:00
DEFAULT DRAIN TIME 00:00
DEFAULT DISTR. TIME 00:00
DO UNBALANCE MEASUREMENT N
DRAIN OPEN DELAY 0:13
START EXTRACT TIME 00:30
1 2 3
4 5 6
7 8 9
0
Level empty
Here you determine the water level at which the
drum will be regarded as empty.
It is advisable to set this level so that the inner
drum will have emptied, but so that some water
remains in the outer drum.
If the water has not fallen to this level before the
drain time has ended, the message ”NOT DRAI-
NED” will appear on the display.
For information on the levels used for the various
machines, see the manual ”Programming, PCS
Program Control Unit”.
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
Level for over-filled drum
Here you determine the water level at which the
drumwillberegardedasover-lled.
Over-llingcanoccurifawatervalveisfaulty,orif
youhaveover-lledthemachinemanually.
For information on the levels used for the various
machines, see the manual ”Programming, PCS
Program Control Unit”.
Under ”SETTINGS 2” (i.e. later in this section) there
aretwofunctionswhichinuencethewaythe
machinereactstoover-lling:
”DRAIN TIME WHEN OVERFILL”
(i.e.DRAINTIMEAFTEROVER-FILLING)
If you have the answer N (No) inserted for the
function”ERROROVER-FILLED”(described
below, this page), the drain valve will open and
discharge water for the time inserted as a para-
meter under ””DRAIN TIME WHEN OVERFILL”.
The level will be checked after that, and the
same sequence will be repeated until the level is
back to normal.
ERROROVER-FILLED
If you answer Y (Yes): if the drum becomes
over-lled,themachinewillstopandtheerror
message”MACHINEOVER-FILLED”willbe
displayed.
If you answer N (No): the drain valve will open
as described above.