WBOX Technologies 0E-13D28 - Setting Pppoe Parameters

High-Resolution IR Camera
User Manual
Web Operation
Issue V1.0 (2018-05-11)
55
Parameter
Description
Setting
Provider
DDNS service provider.
Currently, only 3322 and
DynDns are supported.
[Setting method]
Select a value from the drop-down
list box.
[Default value]
WBoxDDNS
NOTE
Set this parameter based on the site
requirements.
Host Name
Host name customized by a
user.
[Setting method]
Enter a value manually.
[Default value]
Blank
Test DDNS
Test if the device connects to
DDNS successfully.
[Setting method]
Click Test, if the device connects to
DDNS successfully, the message
“Test CGI alarm success” is
displayed.
Step 4 Click Apply.

If the message "Apply success!" is displayed, and the system saves the settings.

If other information is displayed, set the parameters correctly.
----End
4.8.3 Setting PPPoE Parameters
Preparation
Obtain the PPPoE user name and password from the network carrier.
Description
If a PPPoE connection is used, you need to enter the user name and password on the
PPPoE page. After you restart the device, the PPPoE settings take effect and the device
obtains a public IP address.
Procedure
Step 1 Choose Configuration > Network Service > PPPoE.
The PPPoE page is displayed, as shown in Figure 4-28.