WBOX Technologies 0E-13D28 - Setting Local Network Parameters

Web Operation
High-Resolution IR Camera
User Manual
30
Issue V1.0 (2018-05-11)
Parameter
Description
Setting
OFF
Area ID
ROI area ID
[Setting method]
Select a value from the
drop-down list box.
[Default value]
1
Level
Visual effect of ROI. The higher the
grade is, the more clearly areas inside and
the vaguer areas outside are..
[Setting method]
Select a value from the
drop-down list box.
[Default value]
5
Area Name
The marked name used for areas.
[Setting method]
Enter a value manually.
The value cannot exceed
32 bytes.
Step 3 Click Apply.
The message "Apply success!" is displayed, and the system saves the settings.
----End
4.4.4 Setting Local Network Parameters
Description
Local network parameters include:

IP protocol

IP address

Subnet mask

Default gateway

Dynamic Host Configuration Protocol (DHCP)

Preferred Domain Name System (DNS) server

Alternate DNS server

MTU
Procedure
Step 1 Choose Device Configuration > Local Network.
The Local Network page is displayed, as shown in Figure 4-11.