High-Resolution IR Camera
User Manual
Procedure
Step 1 Choose Configuration > Protocol > Security.
The Security page is displayed as shown in Figure 4-39. Table 4-27 describes the
parameters on the Security page.
Figure 4-39 Security page
Table 4-27 Parameter description
When you select the User Verification
check box, the user name and password
must be the same as those for logging in
to the device web page.
NOTE
The default user name is admin, and the
default password is admin.
[Setting method]
Click the button on
to enable User
Verification.
Step 2 Click Apply.
A dialog box is displayed, indicating the parameter configuration success. To make the
configuration take effect, click Confirm to restart the device.
----End
4.10.3 Setting Multicast Parameters
Description
You can set multicast IP, video port, audio port and source port in multicast parameter
page.
Procedure
Step 1 Choose Configuration > Protocol > Multicast Param.
The Multicast Param page is displayed as shown in Figure 4-40. Table 4-28 describes
the parameters on the Multicast Param page.
To Next Page
Loading...
