Webdyn WebdynSunPM - Page 166

166
USER MANUAL – WebdynSunPM
Version 2.05
préliminaire
Parameter
Description
Default value
NTP_Server2
2
nd
server to query to set the date/time.
This server is used if the 1
st
server does not
respond.
NTP_TimeZone
Time zone to apply. This value is used jointly
with the time data returned by the
configured NTP servers.
See appendix “Appendix B: Time zone list”
for this list of authorised values
UTC
SERVER_Address
The remote server address to use to
connect to Server 1
This address can be a name if the DNSs are
properly configured or an IP address.
This value is mandatory.
SERVER_Interface
Network interface to use to access the
remote server for the Server 1 connection.
The possible values are:
• ethernet: uses the ethernet
connection
• modem: uses the 3G interface with
the embedded SIM card
This parameter cannot be empty
ethernet
SERVER_Type
The type of server to which the
concentrator is to connect for the Server 1
connection.
There are several different server types. It is
therefore important to select the right
server type.
The possible values are:
• ftp: FTP server
• sftp: SFTP server
• mqtt: MQTT server
• mqtts: secure MQTT server
• mqtts_aws: MQTTS server on “AWS
IoT”
• mqtts_gcloud: MQTTS server on
“Google Cloud IoT”
This parameter cannot be empty
ftp
SERVER2_Address
The remote server address to use to
connect to Server 2
This address can be a name if the DNSs are
properly configured or an IP address.
This value is mandatory.
SERVER2_Interface
Network interface to use to access the
remote server for FTP 2 connection.
The possible values are:
modem