WebGate EH1600L - Page 32

Install&User Manual
３１
(3) Select On/Off using [◀/▶] arrow button and press [ESC] button.
NTP
(1)Select NTP Function
(2)Select “Client or Server or Both” using [◀/▶] or [▲/▼] arrow button and press [Enter] button.
(3)Select “Public or Both” using [◀/▶] arrow button and press [ESC] button
on ‘Client or Both’mode.
(4) Enter ‘Server IP address’ when you set the next server as Local.
(5) Set Server and Communicate cycle with Interval.
Date Format
(1) Select “Date Format” using [◀/▶] or [▲/▼] arrow button and press [Enter] button. Select a
value using [◀/▶] arrow button from YYYY/MM/DD, MM/DD/YYYY, DD/MM/YYYY.
(2) Press [ESC] after finshing value setting.
Time
(1) Select “Time” using [◀/▶] or [▲/▼] arrow button and press [Enter] button.
(2) Select Date, Time using [◀/▶] arrow button and set value using [▲/▼] arrow button.
(3) Press [ESC] after finshing value setting.
Apply
Most setting values are appled automatically, when exiting form the related menu page. But
“Date” & “Time” setting are not applied automatically because they may critically affect the file
system of the recorded HDD. To apply Date/ Time settings confirm with [Apply Date/Time]
buttons.
(1) Select “Apply Date/ Time” using [◀/▶] or [▲/▼] arrow button and press [Enter]. Then, a
warning message will be appeared as below image;
(2) Select using [◀/▶] or [▲/▼] arrow button and select “YES”, then, press [ENTER] button.
To cancel, press [ESC] button.